OTRA-Based Multi-Function Inverse Filter Configuration

Abdhesh Kumar Singh, Ashish Gupta, Raj Senani

OTRA-Based Multi-Function Inverse Filter Configuration

Číslo: 5/2017
Periodikum: Advances in Electrical and Electronic Engineering
DOI: 10.15598/aeee.v15i5.2572

Klíčová slova: Analogue signal processing; inverse active filters; Operational Transresistance Amplifier, Zpracování analogových signálů; inverzní aktivní filtry; Operační zesilovač pro transzistenci.

Pro získání musíte mít účet v Citace PRO.

Přečíst po přihlášení

Anotace: A new OTRA-based multifunction Inverse filter configuration is presented which is capable of realizing low pass, high pass and band pass filters using only two OTRAs and five to six passive elements. To the best knowledge of the authors, any inverse filter configuration using OTRAs has not been reported in the literature earlier. The effect of the major parasitics of the OTRAs and their effect on the performance filter have been investigated and measured through simulation results and Monte-Carlo analysis. The workability of the proposed circuits has been confirmed by SPICE simulations using CMOS-based-OTRA realizable in 0.18 µm CMOS technology. The proposed circuits are the only ones which provide simultaneously the following features: use of reasonable number of active elements (only 2), realizability of all the three basic filter functions, employment of all virtually grounded resistors and capacitors and tunability of all filter parameters (except gain factor, H_0 for inverse high pass).

The centre/cut-off frequency of the various filter circuits lying in the vicinity of 1 MHz have been found to be realizable, which has been verified through SPICE simulation results and have been found to be in good agreement with the theoretical results.